785 Bond Strength to Enamel Using 5th and 6th Generation Adhesives

Friday, March 23, 2012: 2 p.m. - 3:15 p.m.
Location: East Hall (Tampa Convention Center)
Presentation Type: Poster Session
M. ELDIWANY, Dept of General Dentistry, University of Texas at Houston, Houston, TX, J. ONTIVEROS, Dept. of Restorative & Biomaterials, University of Texas at Houston, Houston, TX, S. HUQUE, Restorative Dentistry and Biomaterial, University of Texas - Houston/Health Science Center, Houston, TX, and M. ELDIWANY, Restorative Dentistry and Biomaterials, University of Texas - Houston/Health Science Center, Houston, TX
Objectives: To determine the shear bond strengths of different dental adhesives on enamel

Methods: Human molars and pre-molars were ground to 60 grit creating a flat surface on the enamel and polished to 320 grit. The five adhesives utilized were Moxie TE/5th generation and Moxie SE/6th generation (Discus Dental); OptiBond Solo Plus/5th generation and Optibond XTR /6th generation (KerrSybron); and Clearfil SE Protect Bond/6th generation (Kuraray). Composite resin (SDI Glacier) was bonded and cured to the enamel according to manufacturer’s instructions. Specimens (n=10; cylinder mold, d=2.3) were stored in 100% humidity at 37°C for 24 hours. An Instron was utilized to load specimens and calculate the shear bond strength in megapascals (MPa). Analysis was performed using ANOVA and post hoc Tukey test at 0.05 level of significance.

Results: : The mean bond strengths, MPa, and standard deviations of the five adhesives were: Moxie TE 12.0 (5.0), Moxie SE 9.3 (4.1), OptiBond Solo Plus 11.2 (1.8), Optibond XTR 11.7 (3.6), and Clearfil SE Protect Bond 15.0 (4.9). No adhesives were significantly different from each other except between Clearafil SE Protect Bond and Moxie SE (p=0.02).

Conclusions:

Enamel bond strengths were similar among Moxie TE, Moxie SE, OptiBond Solo Plus and Optibond XTR, p>0.05, while Clearfil SE Protect Bond was significantly greater than Moxie SE. Acknowledgements: Materials were provided by manufacturers.


Keywords: Dentin bonding agents and Enamel