Seq #184 Friday, 8 March 2002

11:00 AM-12:15 PM San Diego Convention Center Exhibit Hall C, Poster Session
Ceramics, Composition, Properties, and Fabrication
 
1936  11:00 AM Influence of surface roughness on cone crack formation in glass-ceramic
T. YAMAMOTO, R. NISHIURA, T. SAMPEI, and A. KOHNO, Tsurumi University School of Dental Medicine, Yokohama, Japan
1937  11:15 AM Effect of Deposition Conditions on the Strength of a Sputter-Coated Dental Ceramic
D.E. RUDDELL, B.R. STONER, and J.Y. THOMPSON, University of North Carolina Chapel Hill, USA
1938  11:30 AM Relationship between the mechanical properties and crystalline structure of the submicronic Al2O3-ZrO2 ceramics
S. KOMATSU1, H. AOYAGI1, K. KAKUTA1, H. OGURA1, Y. HATA1, and Q.B. WAN2, 1The Nippon Dental University, School of Dentistry at Niigata, Japan, 2West China University of Medical Sciences, Chengdu, China
1939  11:45 AM Improved Contraction of Porcelain Inlays by CIP Method
C. KAWAMOTO, J. KONISHI, F. WATARI, and H. SANO, Hokkaido University, Sapporo, Japan
1940  12:00 PM In-vitro Wear Assessment of Feldspathic and Low-Fusing Porcelain vs. Enamel
M.A. LATTA, J.L. SHEETS, and B. SIMISTER, Creighton University School of Dentistry, Omaha, NE, USA
1941  12:15 PM Maximum load to fracture of resin cement from sintered ceramic materials
A. MACEDO, J. DELGADO, M. SIERRAALTA, and M. RAZZOOG, The University of Michigan, Ann Arbor, USA
1942  12:30 PM Cross-section microhardness analysis of alumina ceramic after glass infiltration
M.K. ITINOCHE, M.A.J. ARAUJO, E. MIYASHITA, A.A. CATRO FILHO, D.K. OYAFUSO, and M.A. BOTTINO, São José dos Campos University, UNESP - School of Dentistry, São Paulo, Brazil
1943  12:45 PM The Mechanical Properties of Three Pressable All-ceramic Dental Materials
M. ALBAKRY, M. GUAZZATO, and M. SWAIN, The University of Sydney, Australia
1944  1:00 PM Crystal size and their distribution in hot-pressed Empress ceramics
N.-Z. ZHANG, and K.J. ANUSAVICE, University of Florida, Gainesville, USA
1945  1:15 PM Bilayered ceramic spheres:Useful test for thermal incompatibility?
A.A. BARRETT1, K.J. ANUSAVICE1, and P.H. DEHOFF2, 1University of Florida, Gainesville, USA, 2University of North Carolina Charlotte, USA
1946  1:30 PM Cyclic Fatigue Behavior of Baria-Silicate Glass-Ceramics
K. SUPUTTAMONGKOL, K.J. ANUSAVICE, and J.J. MECHOLSKY, University of Florida, Gainesville, USA
1947  1:45 PM Flexural Strength of a New Ceramic Core Material
R.P. RUSIN, R.F. MURPHY, and J.C. ROLF, 3M ESPE Dental Products, St. Paul, MN, USA
1948  2:00 PM Impact Stress propagation in Diopside Glass-Ceramic Bridge
K. MURASE, Kinki University, Higashihirosima, Japan, S. TSUTSUMI, Kyoto University, Japan, and M. FUKUMA, Osaka Dental Institute College, Japan
1949  2:15 PM Flexural resistance of glass-infiltrated porcelain after repairing
E. MIYASHITA, M.K. ITINOCHE, L.G. VAZ, M.A. BOTTINO, and M.A.J. ARAUJO, São José dos Campos University, UNESP - School of Dentistry, São Paulo, Brazil

Back to the: Dental Materials: III - Ceramics and Cements Program

Back to the IADR/AADR/CADR 80th General Session (March 6-9, 2002)

Top Level Search