| | |
| 1208 |
3:45 PM | The influence of the intrinsic characterization technique and post packing periods on hardness, surface roughness and porosity of a microwave cured acrylic resin
M.F. MESQUITA1, M.A.B. ALMEIDA2, G.E.P. HENRIQUES1, M.A.D.A. NÓBILO1, and R.L.X. CONSANI1, 1Campinas State University, Piracicaba-SP, Brazil, 2UBERABA UNIVERSITY, Uberaba, Brazil |
| 1209 |
4:00 PM | In vitro evaluation of wear, superficial roughness and sorption of glass ionomer cements used as fissure sealants
D. RIOS, H.M. HONÓRIO, P.A. ARAÚJO, and M.A.A.M. MACHADO, Bauru Dental School- University of São Paulo, Brazil |
| 1210 |
| WITHDRAWN
| | 1211 |
4:30 PM | Flexural Strength of Fourteen Cements
G. BAUDIN II, and J.O. BURGESS, LSUHSC School of Dentistry, New Orleans, LA, USA |
| 1212 |
4:45 PM | Mechanical Property and Fracture Characterization of Resin Cement after Aqueous Aging with and without Cyclic Loading
M.P. WALKER1, P. SPENCER2, J.D. EICK2, A. GLAROS2, Y.-S. LAU3, and A. HOLDER4, 1University of Nebraska Medical Center College of Dentistry, Linocln, USA, 2University of Missouri-Kansas City, School of Dentistry, USA, 3University of Missouri-Kansas City, USA, 4University of Missouri-Kansas City, NE, USA |
| 1213 |
5:00 PM | Effects of disinfection solutions on the long-term hardness of heat-cured acrylic resins
K.H. NEPPELENBROEK, A.C. PAVARINA, C.E. VERGANI, A.L. MACHADO, and E.T. GIAMPAOLO, São Paulo State University, Araraquara, Brazil |
| 1214 |
5:15 PM | Effect of Loading Rate on Strength of Six Glass-Ionomer Cements
T. YAMAZAKI, S.R. SCHRICKER, W.A. BRANTLEY, W.M. JOHNSTON, and B.M. CULBERTSON, Ohio State University, Columbus, USA |
| 1215 |
5:30 PM | Characterization of Vinylpolysiloxane Soft Denture Relining Materials
D. XIE, L. HUYNH, and E. SHELLARD, Kerr Corporation, Orange, CA, USA |
| 1216 |
5:45 PM | Effect of microwave irradiation on the flexure strength of one hard chairside reline resin
R. SEO, C.E. VERGANI, A.L. MACHADO, E.T. GIAMPAOLO, and A.C. PAVARINA, São Paulo State University, Araraquara, Brazil |
| 1217 |
6:00 PM | Suitability of Sapphire as a complete denture impression material
J. ASTROTH, J. KIM, and J.W. STANSBURY, University of Colorado Health Sciences Center, Denver, USA |
| 1218 |
6:15 PM | Comparison of Transverse Strength of 6 Heat-cured Acrylic Resins between Short Wet-cured and Microwave-cured Techniques
W. PANYAYONG, P. DAOSODSAI, and C. CHEUN-ARROM, Prince of Songkhla University, Thailand |
| 1219 |
6:30 PM | Wear rates of occlusal orthotic device materials
J. CASEY1, E. WRIGHT1, W. DUNN, and R. MCDANIEL, 1Wilford Hall Medical Center, Lackland AFB, TX, USA |
| 1220 |
6:45 PM | Surface Deterioration of soft denture liners
Y. SATOH1, E. NAGAI1, I. AKIYAMA1, K. OTANI1, S. NAKAJIMA1, S. SUZUKI2, and T. ISHIGAMI3, 1Nihon University School of Dentistry, Tokyo, Japan, 2University of Alabama at Birmingham, Tokyo, Japan, 3Nihon University School of Dentistry, Japan |
| 1221 |
7:00 PM | In Vitro Wear of Nano-Composite Denture Teeth
S. SUZUKI, and F. TAMURA, University of Alabama at Birmingham, USA |
|